D-Link DIR-600L User Manual

52D-Link DIR-600L User Manual
Section 4 - Security
Congure WPA/WPA2-PSK
It is recommended to enable encryption on your wireless Router before your wireless network adapters. Please establish
wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption due to the
added overhead.
1. Log into the web-based conguration by opening a web browser and
entering the IP address of the router (192.168.0.1). Click on Wireless
Setup on the left side.
2. Next to Security Mode, select Enable WPA/WPA2 Wireless Security
(enhanced).
3. Next to Cipher Mode, select TKIP, AES, or Both.
4. Next to PSK/EAP, select PSK.
5. Next to Network Key, enter a key (passphrase). The key is an alpha-numeric password
between 8 and 63 characters long. The password can include symbols (!?*&_) and spaces.
Make sure you enter this key exactly the same on all other wireless clients.
6. Click Save Settings to save your settings. If you are conguring the Router with a wireless adapter, you will lose connectivity
until you enable WPA/WPA2-PSK on your adapter and enter the same passphrase as you did on the Router.

D-Link DIR-600L Specifications

Power

power input voltage	5 V DC
power input current	1 A

Operating Environment

operating temperature	32 to 104 ˚F (0 to 40 ˚C)
operating humidity	0% to 90% non-condensing
wireless frequency range	2.4 GHz to 2.4835 GHz

Weight and Dimensions

dimensions	112 x 152 x 28 mm
weight	0.5 lb