10D-Link DIR-819 User Manual
Section 2 - Installation
4. Use the included Ethernet cable to connect your modem to the yellow port labeled INTERNET on the router.
5. Turn on or plug your modem back in and wait approximately one minute before proceeding onward.
6. Connect the supplied power adapter to the router and a power outlet, press the power button, and verify that the power LED is lit. Allow
1 minute for the router to boot up.
Hardware Setup (continued)
INTERNET
POWER POWER PORT WPS
4321
RESET
DIR-819
INTERNET
POWER POWER PORT WPS
4321
RESET
DIR-819
Modem
INTERNET
POWER POWER PORT WPS
4321
RESET
DIR-819
Modem
Modem
To Next Page
Loading...
