D-Link DIR-819 - Page 44

40D-Link DIR-819 User Manual
Section 3 - Conguration
INTERNET CONNECTION TYPE
Choose the mode to be used by the router to connect to the Internet.
My Internet Connection is :
L2TP (Username / Password)
▼
Save Settings Don’t Save Settings
L2TP INTERNET CONNECTION TYPE :
Enter the information provided by your Internet Service Provider (ISP).
Address Mode :
 Dynamic IP  Static IP
L2TP IP Address :
L2TP Subnet Mask :
L2TP Gateway IP Address :
L2TP Server IP Address :
Username :
Password :
Verify Password :
Reconnect Mode :

AlwaysOn
▼
New Schedule

On Demand  Manual
Maximum Idle Time :
(minutes)
Primary DNS Server :
Secondary DNS Server : (optional)
MTU : 1492
MAC Address :
Clone Your PC’s MAC Address
WANINTERNET
DIR-819
SETUP
WAN
Use this section to congure your Internet Connection type. There are several connection types to choose from: Static IP, DHCP, PPPoE,
PPTP, L2TP, and DS-Lite. If you are unsure of your connection method, please contact your Internet Service Provider.
Note : If using the PPPoE option, you will need to remove or disable any PPPoE client software on your computers.
Save Settings Don’t Save Settings
L2TP (Username / Password)
Address Mode: Select either Dynamic IP or Static IP
If you choose Static IP as the Address Mode, enter your IP address:
L2TP IP Address: Enter the PPTP IP Address provided by your ISP.
L2TP Subnet
Mask:
Enter the PPTP Subnet mask provided by your ISP.
L2TP Gateway IP
ddress:
Enter the PPTP Gateway IP Address provided by your ISP.
If you choose Dynamic IP or Static IP as the Address Mode, enter your PPTP Server IP
address:
L2TP Server IP
Address:
Enter the PPTP Server IP address provided by your ISP.
Username: Enter the username provided by your ISP.
Password: Enter the password provided by your ISP.
Verify Password: Enter the password provided by your ISP one more time.
Reconnect Mode: Select either AlwaysOn, On Demand, or Manual. You may create
a schedule by clicking New Schedule. Refer to Schedules on page
110 for more information.
If you choose Manual as the Reconnect Mode, enter the Maximum Idle Time:
L2TP INTERNET CONNECTION TYPE :
If you choose L2TP, please congure the following elds: