DIR-825/AC Wireless AC1200 Dual Band Gigabit Router with
3G/LTE Support and USB Port
User Manual
Configuring via Web-based Interface
Figure 135. The page for changing the settings of the router's port.
On the opened page, specify the needed parameters:
Parameter Description
Port WAN / LAN
Speed Data transfer mode.
Select the Auto value to enable autonegotiation. When this value is
selected, the Autonegotiation modes and Flow control
sections are displayed.
Select the 10M-Half, 10M-Full, 100M-Half, or 100M-Full value
to manually configure speed and duplex mode for the selected port:
• 10M-Half: Data transfer in just one direction at a time (data
can be either sent or received) at the maximum possible rate
of up to 10Mbps.
• 10M-Full: Data transfer in two directions simultaneously
(data can be sent and received at the same time) at the
maximum possible rate of up to 10Mbps.
• 100M-Half: Data transfer in just one direction at a time (data
can be either sent or received) at the maximum possible rate
Page 177 of 257
To Next Page
Loading...
