DIR-825/AC Wireless AC1200 Dual Band Gigabit Router with
3G/LTE Support and USB Port
User Manual
Configuring via Web-based Interface
To edit fields in the Tunneled networks section, select a needed field in the relevant line of the
table and change its value.
To remove IP addresses of subnets, select the checkbox located to the left of the relevant line in the
table and click the Delete button.
Click the Apply button.
After clicking the Apply button, the page with the sections IPsec and Status opens.
To edit the parameters of an existing tunnel, in the IPsec section, select the relevant tunnel in the
table. On the opened page, change the needed parameters and click the Apply button.
To remove an existing tunnel, select the checkbox located to the left of the relevant line in the table
and click the Delete button.
In the Status section, the current state of an existing tunnel is displayed.
To disable VPN tunnels based on IPsec protocol, deselect the Enabled checkbox.
Page 203 of 257
To Next Page
Loading...
