DIR-825/AC Wireless AC1200 Dual Band Gigabit Router with
3G/LTE Support and USB Port
User Manual
Configuring via Web-based Interface
Parameter Description
Private port (begin)/
Private port (end)
A port of the IP address specified in the Private IP field to which
traffic is directed from the Public port. Specify the start and the
end value for the port range. If you need to specify one port, enter
the needed value in the Private port (begin) field and leave the
Private port (end) field blank.
Private IP
The IP address of the server from the local area network. To choose
a device connected to the router's LAN at the moment, select the
relevant value from the drop-down list (the field will be filled in
automatically).
Remote IP
The IP address of the server from the external network.
Enable NAT Loopback
Select the checkbox in order to let the users of the router's LAN
access the local server using the external IP address of the router or
its DDNS name (if a DDNS service is configured). Users from the
external network access the router using the same address (or DDNS
name).
Click the Apply button.
To edit the parameters of an existing server, select the relevant server in the table. On the opened
page, change the needed parameters and click the Apply button.
To remove a server, select the checkbox located to the left of the relevant line in the table and click
the Delete button. Also you can remove a server on the editing page.
To remove all servers from this page, click the Clear all button.
In the Remote access configuration section, rules created on the Advanced / Remote
access to device page are displayed. If after creating virtual servers you need to edit rules for
remote access, you can quickly get to the Advanced / Remote access to device page by
clicking the link to the relevant rule.
Page 209 of 257
To Next Page
Loading...
