D-Link DIR-868L - System Log

117D-Link DIR-868L User Manual
Section 4 - Conguration
System Log
Check this box to send the router logs to a SysLog server. If this is disabled, there
will be no other options on this page.
Enter the IP address for the Syslog server. If the Syslog server is connected to the
router, select it from the drop-down menu to automatically populate the eld.
If you want the logs to be automatically sent to an email address, enable this option.
Enter the settings for your email account. These are obtained from your email
service provider.
Enter the IP address for your SMTP server.
Enter the port for your SMTP server.
Enable or disable authentication.
If email notication is enabled, this option will set the router to send the log by
email when the log is fully.
This option can be enabled to send an email according to a pre-congured
schedule. See below.
If you enable On Schedule is enabled, use the drop-down menu to select the
time schedule that the rule will be enabled on. The schedule may be set to Always
Enable, or you can create your own schedules in the Schedules section (refer to
page 116). Click Save when you are done.
Enable Logging to
Syslog Server:
Syslog Server IP
Address:
Enable E-mail
Notication:
From/To E-mail
Addresses:
SMTP Server
Address:
SMTP Server Port:
Enable
Authentication:
Send When Log Full:
Send On Schedule:
Schedule:
The router keeps a running log of events. This log can be sent to a Syslog server, and
sent to your email address. In the Management menu on the bar on the top of the
page, click System Log.