D-Link DSL-G256DG VDSL Router User Manual
Web User Interface Configuration Page 65
In this section we can configure the advanced wireless settings.
Band: This parameter will display the current wireless band being configured.
Channel: Automatically set or select a channel option.
Auto Channel Timer: Enter the auto channel timer value used here.
802.11n/EWC: Select this 802.11n/EWC option used here. Options to choose from
are Auto and Disabled.
Bandwidth: Select between 20MHz or Auto 20/40MHz
802.11n Rate: Select the 802.11n rate used here.
802.11n Protection: Select this 802.11n protection option used here. Options to
choose from are Auto and Off.
Support 802.11n Client Only: Select the support for 802.11n clients only option
used here. Options to choose from are On and Off.
RIFS Advertisement: Select the RIFS advertisement option used here. Options to
choose from are Auto and Off.
OBSS Coexistence: Select the OBSS co-existence state here. Options to choose
from are Enable and Disable.
RX Chain Power Save: Select the RX chain power save state here. Options to choose from are Enable or Disable.
Power Save status: This parameter will display the power save status.
RX Chain Power Save Quiet Time: Enter the RX chain power save quiet time value used here. This option becomes available after the RX Chain Power Save was
enabled.
RX Chain Power Save PPS: Enter the RX chain power save PPS value used here. This option becomes available after the RX Chain Power Save was enabled.
To Next Page
Loading...
Need help?
General
