26D-Link DSP-W215 User Manual
Section 4 - Connect to a Wireless Router
Connecting to a Wireless Router
WPS Button
WPS (Wi-Fi Protected Setup) is a simple and secure way to connect your DSP-W215 to your network. Please refer to the user
manual for the wireless router you want to connect to make sure you understand how to enable WPS. Once you know, follow
the steps below:
Step 1 - Press the WPS button on your wireless device.
Step 2 - Press the WPS button on the DSP-W215 for about 1 second. The status LED on the device will start to blink.
Step 3 - Once the Status LED light stops blinking and turns solid green, you will be connected and your wireless connection
will be secured. If WPS connection is not successfully established, the LED will blink in orange again. Simply press the
WPS button on the router and the Smart Plug and try to establish the connection again.
WPS Button
To Next Page
Loading...
