To mount the driver, go to the LINUX2.6.9_REV111 directory and executing the following command:
[root@localhost linux2.6.9_rev111]# insmod usbnet
or
[root@localhost anywhere]# modprobe usbnet
To unmount the driver, just typing the following command:
[root@localhost anywhere]# rmmod usbnet
Installation is Complete!
Installation of the DUB-E100 is complete. The LINK LED should be solid green, indicating a good physical
connection between the DUB-E100 and the network. The TX/RX LED indicates when data is being
transmitted or received. If both LEDs are unlit, there may be a problem with the physical connection. Check
the cables between your DUB-E100, the computer, and the network. Verify that your network switch, hub, or
router is powered on.
18
To Next Page
Loading...
