Please note that this type of installation requires that your
Residential Gateway, Router, Firewall or Network Administrator
can give you a dynamic IP address for each computer. Please
consult the documentation that comes with your Access Point to
determine its necessary configuration.
To complete this installation, please follow these steps:
1.Using the provided Ethernet cable, connect the router to the
Cable/DSLmodem. Also connect the Access Point to the Router.
2. Install the Wireless Adapter - see the Quick Install Guides.
3. Check the wireless connection- see Configuration Utility and
Networking Basics section.
4. Check IP Address for the wireless adapter - see Networking Basics
section.
NOTE: The default settings for the wireless adapter is set to obtain a
Dynamic IP Address.
5. Learn to share printers and files - see Networking Basics section.
4
To Next Page
Loading...
