802.11 a/g Dual Band Access Point Command Line Interface Manual
11
get multi-idv-acct-sta [index] Dislay Individual Accounting State for Multi-SSID get multi-idv-acct-sta [index]
get multi-idv-acct-srv [index] Dislay Individual Accounting Server for Multi-SSID get multi-idv-acct-srv [index]
get multi-idv-acct-port [index] Dislay Individual Accounting Server Port for Multi-SSID get multi-idv-acct-port [index]
Help Command:
Help Display CLI Command List help or ?
Ping Command:
Ping Ping ping <xxx.xxx.xxx.xxx:FQDN>
Restart and Exit Commands:
Reboot
Reboot Access Point. It is necessary to reboot the AP after making
configuration changes for those changes to take effect.
reboot
Quit Logoff quit
SET Commands:
set 11gonly Only 802.11g clients will be Allowed to connect to this BSS set 11gonly [disable:enable]
set acl enable Select ACL restricted access to specified MAC addresses set acl enable
set acl disable Select Unrestricted access set acl disable
set acl allow Add specified MAC address to the allow ACL set acl allow <xx:xx:xx:xx:xx:xx>
set acl deny Add specified MAC address to the deny ACL set acl deny <xx:xx:xx:xx:xx:xx>
set acl strict
Select Restricted Access, only clients with authorized MAC will
communicate
set acl strict
set acl keymap Add WEP Encryption Key mapping for MAC Address
set acl keymap <xx:xx:xx:xx:xx:xx> [1-4]
set acl keymap <xx:xx:xx:xx:xx:xx> default
set acl keymap <xx:xx:xx:xx:xx:xx> [40:104:128] < value>
set wdsacl allow Add MAC Address to WDS List set wdsacl allow <xx:xx:xx:xx:xx:xx>
set aging Set Aging Interval set aging seconds
set antenna Set Antenna selection of 1, 2, or best set antenna [1:2:best]
set authentication Set Authentication Type
set authentication [open-system:shared-key:auto:WPA: WPA-PSK:
WPA2: WPA2-PSK:WPA-AUTo:WAP2-AUTP-PSK]
set autochannelselect Set Auto Channel Selection to enable or disable set autochannelselect [disable:enable]
set apmode
Set AP Mode to Normal AP, Point to Point Bridge, Point to Multipoint
Bridge, AP Repeater, or AP Client
set apmode [ap:p2p:p2mp:p2pwithoutap: p2mpwithoutap]
set beaconinterval Modify Beacon Interval 20-1000 set beaconinterval [20-1000]
set channel Select Radio Channel of Operation set channel [1:2:3:4:5:6:7:8:9:10:11]
set cipher Set Cipher of wep, aes, tkip, or auto negotiate set cipher [wep:aes:tkip:auto]
set cpuloadlimit Set CPU Load Limit set cpuloadlimit [0-100]
set cpuloadperoid Set CPU Load Period set cpuloadperoid [0-100]
set dhcpc Set DHCP Clinet State of enable or disabled
set dhcpc [0:1]
To Next Page
Loading...
