802.11 a/g Dual Band Access Point Command Line Interface Manual
12
set diap Enable or Disable DIAP set diap [disable:enable]
set dtim Set Delivery Traffic Indication Message Beacon Rate. Default is 1 set dtim <1-255>
set encryption Enable or Disable Encryption Mode set encryption [disable:enable]
set eth2wlan Enable or Disable the Eth2Wlan Broadcast packet filter feature
set eth2wlan [0:1]
Explanation: 0=disable:1=enable
set factorydefault Restore to Default Factory Settings set factorydefault
set fragmentthreshold Set Fragment Threshold set fragmentationthreshold <xxxx>
set frequency Set Radio Frequency (MHz) set frequency <24xx>
set gateway Set Gateway IP Address
set gateway <xxx.xxx.xxx.xxx>
Explanation: <xxx.xxx.xxx.xxx> is IP address
set groupkeyupdate Set Group Key Update Interval (in Seconds) for TKIP set groupkeyupdate seconds
set snmp Set SNMP State set snmp [disable:enable]
set ipaddr Set IP Address
set ipaddr <xxx.xxx.xxx.xxx>
Explanation: <xxx.xxx.xxx.xxx> is IP address
set ipmask Set IP Network/Subnet Mask
set ipmask < xxx.xxx.xxx.xxx>
Explanation: <xxx.xxx.xxx.xxx> is Network mask
set key Used to set the specified wep key value and size
set key [1-4] default
set key [1-4] [40:104:128] < value>
set keyentrymethod Select Between ASCII or HEX encryption key format set keyentrymethod [asciitext : hexadecimal]
set keysource Select Source of Encryption Keys: static(flash), dynamic (server), mixed set keysource [flash:server:mixed]
set login Modify Login User Name set login <username>
set syslog Set sysLog setting
set syslog remoteip <xxx.xxx.xxx.xxx>
set syslog remotestate [0:1]
set syslog localstate [0:1]
set syslog sysstate [0:1]
set syslog wirelessstate [0:1]
set syslog othersestate [0:1]
set syslog clear all
Explanation: 0=disable:1=enable
set password Modify Password set password <new password>
set passphrase Modify Passphrase set passphrase <new passphrase>
set power Set Transmit Power in predefined increments set power [full:half:quarter:eighth:min]
set roguestatus Enable or Disalbe Rogue AP function set roguestatus
set roguebsstypestatus Enable or Disalbe Rogue AP BSS Type function set roguebsstypestatus [disable:enable]
set roguebsstype Set Rogue AP BSS Type set roguebsstype [apbss:adhoc:both]
set roguesecuritystatus Enable/Disalbe Rogue AP Security set roguesecuritystatus [disable:enable]
set roguesecurity Set Rogue AP Security Type
set roguesecurity
Note: After enter this command, the CLI will list the security type for
To Next Page
Loading...
