802.11 a/g Dual Band Access Point Command Line Interface Manual
13
set roguebandselectstatus set roguebandselectstatus [disable:enable]
set roguebandselect
set roguebandselect
Note: After enter this command, the CLI will list the security type for
selection
set radiusname Set RADIUS Server name or IP address
set radiusname <DNS name::xxx.xxx.xxx.xxx>
Explanation: <xxx.xxx.xxx.xxx> is IP address
set radiusport Set RADIUS port number
set radiusport <xxxxx>
Explanation: <xxxxx> is port number, default value is 1812
set radiussecret Set RADIUS shared secret set radiussecret
set accountingstate Enable or Disable Accounting server function set accountingstate [disable:enable]
set accountingname Set Accounting server name or IP addresss
set accountingname <DNS name::xxx.xxx.xxx.xxx>
Explanation: <xxx.xxx.xxx.xxx> is IP address
set accountingport Set Accounting port number
set accountingport < xxxxx>
Explanation: < xxxxx> is port number, default value is 1813
set rate Set Data Rate set rate [best:1:2:5.5:6:9:11:12:18:24:36:48:54]
set rtsthreshold Set RTS/CTS Threshold in bytes set rtsthreshold <xxxx>
set shortpreamble Set Short Preamble
set shortpreamble [0:1]
Explanation: 0=disable:1=enable
set sntpserver Set SNTP/NTP Server IP Address
set sntpserver <xxx.xxx.xxx.xxx>
Explanation: <xxx.xxx.xxx.xxx> is IP address
set ssid Set Service Set ID set ssid <SSID>
set ssidsuppress Set SSID Suppress Mode enable or disable
set ssidsuppress [0:1]
Explanation: 0=disable:1=enable
set SuperG Enable or Disable Super G Features
set SuperG [0:1]
Explanation: 0=disable:1=enable
set systemname Specify Access Point System Name set systemname <name>
set sta2sta Set wireless STAs to wireless STAs connect state (WLAN Partition)
set sta2sta [0:1]
Explanation: 0=disable:1=enable
set eth2sta Set ethernet to wireless STAs connect state
set eth2sta [0:1]
Explanation: 0=disable:1=enable
set telnet Set Telnet Access Mode to enabled or disabled
set telnet [0:1]
Explanation: 0=disable:1=enable
set timeout Set Telnet Timeout in seconds, 0 is never, 900s Max set timeout [0-900]
set tzone Set Time Zone Setting
set tzone [0=GMT]
Note: use get tzonelist to get tzone information
set daylightsaving Set Day Light Saving Time
set daylightsaving [0:1]
Explanation: 0=disable:1=enable
set wlanstate Select the operational state of wlan: enabled or disabled
set wlanstate <0:1>[0:1]
Explanation: 0=disable:1=enable
set wirelessmode Used to select the wireless mode of operation for the AP: 11b, 11g, 108g
set wirelessmode [11b:11g:108g]
Enable or Disable WMM Features
To Next Page
Loading...
