D-Link DWL-3200A - Page 16

802.11 a/g Dual Band Access Point Command Line Interface Manual
14
set wmmParamBss ac
Set WMM (EDCA) parameters used by STAs in this BSS
set wmmParamBss ac [AC number] [logCwMin] [logCwMax] [aifs]
[txOpLimit] [acm]
Expanation:
AC number: 0->AC_BE
1->AC_BK
2->AC_BK
3->AC_BK
Exampble:
set wmmParamBss ac 0 4 10 3 0 0
set wmmParam ac
Set WMM (EDCA) parameters used by this AP
set wmmParamBss ac [AC number] [logCwMin] [logCwMax] [aifs]
[txOpLimit] [acm] [ack-policy]
Expanation:
AC number: 0->AC_BE
1->AC_BK
2->AC_BK
3->AC_BK
set smtpserver Set SMTP Server
set smtpserver <DNS name::xxx.xxx.xxx.xxx>
Explanation: <xxx.xxx.xxx.xxx> is IP address
set smtpsender Set SMTP Sender Account set smtpsender <sender Email address>
set smtprecipient Set SMTP Recipient Email Address set smtprecipient <recipient Email address>
set vlanstate
Enable or Disable VLAN
set vlanstate [disable:enable]
Note: Must Enable Multi-SSID firstly
set nativevlan Set Native Vlan Tag set nativevlan
set Vlantag Set VLAN Tag set vlantag <tag value>
set multi-vlantag Set VLAN Tag for Multi-SSID set multi-vlantag <tag value> [index]
set multi-state Enable or Disable Multi-SSID Features set multi-state [disable:enable]
set multi-ind-state Enable or Disable specifically Mulit-SSID set multi-ind-state [disable:enable] [index]
set multi-ssid Set Service Set ID for Multi-SSID set multi-ssid [index] <ssid name>
set multi-ssidsuppress Enable or Disable to broadcast SSID of Multi-SSID set multi-ssidsuppress [disable:enable]
set multi-wmm Enable or Disable WMM mode of Multi-SSID set multi-wmm [disable:enable]
set multi-authentication Set Authentication Type for Multi-SSID
set multi-authentication [open-system:shared-key:wpa:wpa-
psk:wpa2:wpa2-psk:wpa-auto:wpa-auto-psk] [index]
set multi-cipher Set Cipher for Multi-SSID set multi-cipher [wep:aes:tkip:auto]
set multi-encryption Set Encryption Mode for Multi-SSID set multi-encryption [disable:enable] [index]
set multi-keyentrymethod Select Encryption Key Entry Method for Multi-SSID set multi-keyentrymethod [hexadecimal:asciitext] [index]
set multi-key default Set Default Encryption Key set multi-key default
set multi-passphrase Set PassPhrase for Multi-SSID set multi-passphrase [index] <passphrase>
set multi-acct-state Enable or Disable the Accounting Feature of Mulit-SSID mode set multi-acct-state [disable:enable]
set multi-idv-acct-sta Enable or Disable the Individual Accounting Feature of Mulit-SSID mode set multi-idv-acct-sta [disable:enable]
set multi-idv-acct-stv Set Individual Accounting Server of Mulit-SSID mode set multi-idv-acct-str [index]
set multi
-
idv
-
acct
-
port
Set Individual Accounting Server port of Mulit
-
SSID mode
set multi
-
idv
-
acct
-
port
[index]