D-Link DWL-3600AP Quick Installation Guide

4  D-Link DWL-3600AP Quick Install Guide
Power on the access point
To power on the DWL-3600AP, you can use ONE of the following methods:
1. Connect the supplied power adapter
OR
2. Plug one end of an Ethernet cable into the LAN port of the DWL-3600AP and the
other end into a port on a power over Ethernet (PoE) switch.
Congure the access point
To set up and manage the DWL-3600AP, use one of the following methods:
• Manage the access point from the computer: Connect the access point and your
computer directly via a straight-through Ethernet cable.
• Manage the access point from the computer via the Switch or Router: Connect
the access point and your computer to the same switch or router.
• Manage the access point from the computer via the Unied Wireless Switch or
Wireless Controller: Connect the access point to a Unied Wireless Switch or
Wireless Controller. Connect your computer to the same network as that of the
Unied Wireless Switch or Wireless Controller.
Installation

D-Link DWL-3600AP Specifications

General

Frequency band	2.4 GHz
Cabling technology	10/100/1000Base-T(X)
Networking standards	IEEE 802.11g, IEEE 802.11n, IEEE 802.3, IEEE 802.3ab, IEEE 802.3af, IEEE 802.3u
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Maximum data transfer rate	300 Mbit/s
Quality of Service (QoS) support	Yes
Data transfer rate	1 Gbit/s
Wireless technology	802.11 b/g/n
Antennas quantity	2
Antenna gain level (max)	4.7 dBi
Internal	No
Certification	FCC, CE
LED indicators	LAN, Power, WLAN
Interface	RJ-45
WAN connection	Ethernet (RJ-45)
Security algorithms	128-bit WEP, 64-bit WEP, SSID, WPA, WPA2
Storage temperature (T-T)	-20 - 65 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	10 - 90 %
Power supply	8 W
Input current	2.5 A
AC input voltage	5 V

Weight and Dimensions

Weight	635 g
Dimensions (WxDxH)	203 x 203 x 48 mm