D-Link DWL-3600AP Quick Installation Guide

D-Link DWL-3600AP Quick Install Guide  5
Mounting Options
You can mount a DWL-3600AP access point on any of the following types of surfaces:
• Solid surface wall or ceiling
• Tabletop
Cable Requirement
Use a CAT5 cable with an even sheath.
The Ethernet ports on the DWL-3600AP access point cannot accept a CAT5 cable
that has an uneven sheath; the RJ-45 connector on the cable will not fit properly into
the receptacle on the access point.
Wall Installation Recommendations
If you plan to install the DWL-3600AP on a wall or other vertical surfaces, orient the
top of the access point (the side with the LEDs) toward the intended coverage area.
The radio antennas transmit through the top of the access point, not through the
bottom (where the bracket is).
Warning: The DWL-3600AP is designed to receive PoE power only from an
802.3af-compliant source, or from a D-Link-approved power injector. Connecting
an access point to a Power over Ethernet (PoE) device that is not approved by
D-Link can damage the equipment.

D-Link DWL-3600AP Specifications

General

Frequency band	2.4 GHz
Cabling technology	10/100/1000Base-T(X)
Networking standards	IEEE 802.11g, IEEE 802.11n, IEEE 802.3, IEEE 802.3ab, IEEE 802.3af, IEEE 802.3u
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Maximum data transfer rate	300 Mbit/s
Quality of Service (QoS) support	Yes
Data transfer rate	1 Gbit/s
Wireless technology	802.11 b/g/n
Antennas quantity	2
Antenna gain level (max)	4.7 dBi
Internal	No
Certification	FCC, CE
LED indicators	LAN, Power, WLAN
Interface	RJ-45
WAN connection	Ethernet (RJ-45)
Security algorithms	128-bit WEP, 64-bit WEP, SSID, WPA, WPA2
Storage temperature (T-T)	-20 - 65 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	10 - 90 %
Power supply	8 W
Input current	2.5 A
AC input voltage	5 V

Weight and Dimensions

Weight	635 g
Dimensions (WxDxH)	203 x 203 x 48 mm