12
Using the Configuration Utility (continued)
Link Info
SSID:
The Service Set Identifier is
the name assigned to the
wireless network. The fac-
tory SSID setting is
default.
Tx Rate:
The default setting is Auto; Tx Rate settings are automatically determined for
an optimal speed up to a maximum of 54Mbps.
Status:
Displays the MAC address
of the access point or
router to which the
DWL-G122 is associated
Channel:
The default setting is Auto. The channel selection is automatically determined
by the DWL-G122.
Signal Quality:
Displays the signal strength and the link quality of the DWL-G122’s wireless
connection to the access point or router.
Packet Count:
Displays the statistics of the data packets that are transmitted and received.
Frequency:
802.11b indicates that the
DWL-G122 is
communicating in the
2.4GHz band.
Encryption:
You can see if WEP (Wired Equivalent Privacy) is Enabled or Disabled here.
Wireless Mode:
Either Infrastructure or Ad-Hoc will be displayed here. (Please see the Getting
Started section in this manual for an explanation of these two modes.)
Rescan Button:
Rescans for the strongest signal with the current SSID and associates with
that access point or router.
To Next Page
Loading...
