11
J. SSID: The Service Set
Identifier is the name assigned
to the wireless network. The
factory SSID setting is set to
default. Make changes here to
match the SSID on existing
Wireless Router or Access
Point.
K. Wireless Mode:
The factory setting is
set to Infrastructure.
Ad-Hoc mode is used
for peer-to-peer
networking.
L. Data Encryption: The
default setting is set to
Disabled. The adapter
supports WEP when
encryption is enabled.
M. Authentication: You can specify
the authentication mode for the
wireless network. The default setting
is set to Open Authentication.
N. Key Length: When encryption is enabled,
you will have the option to specify the level and
key format of the encryption used. Select the
appropriate Key Index : 1-4 and enter ACSII or
hexadecimal digits in the appropriate field.
J
K
L
M
N
Appendix B (cont.)
Configuration
O
O. IEEE802.1X: When encryption is enabled,
you will have the option to specify if you wish
to use 802.1X authentication.
Please refer to the manual on your driver CD for more in depth information.
To Next Page
Loading...
