D-Link DXS-1210-10TS - Show Errdisable Recovery

DXS-1210 Series Smart Managed Switch CLI Reference Guide
122
Switch# configure terminal
Switch(config)#errdisable recovery cause psecure-violation interval 200
Switch(config)#
This example shows how to enable the auto-recovery option for port security violations.
Switch# configure terminal
Switch(config)#errdisable recovery cause psecurity-violation
Switch(config)#
17-2 show errdisable recovery
This command is used to display the error-disable recovery timer related settings.
show errdisable recovery
Parameters
None.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to verify the settings of the error disable recovery timer.
Example
This example shows how to display the settings of the error disable recovery timer.
Switch(config)#show errdisable recovery
ErrDisable Cause State Interval
---------------------- ---------- ------------
Port Security disabled 120 seconds
Storm Control disabled 120 seconds
ARP Rate disabled 120 seconds
BPDU Attack Protection disabled 120 seconds
DHCP Rate disabled 120 seconds
Loopback Detect enabled 120 seconds
Interfaces that will be recovered at the next timeout:
Interface vlan ErrDisable Cause Time left
---------- ------ ---------------------- ------------
eth1/0/1 - Loopback Detect 105 seconds
eth1/0/2 - Loopback Detect 105 seconds
Switch#