D-Link DXS-1210-10TS - Page 89

D-Link DXS-1210 Series User Manual
83
To define the IPv4 ACL: Select IPv4 and then click the Next button. Click the IPv4 Address, Port, IPv4
DSCP and TCP Flag tabs to display the following page:
Figure 4.140 – ACL > ACL Configuration Wizard – Create IPv4 ACL
Sequence No. (1-65535): Select and enter the ACL rule number. This value must be between 1 and 65535.
Select Auto Assign to automatically generate an ACL rule number for this entry.
Protocol Type: Select the protocol type option. Options to choose from are TCP, UDP, ICMP, EIGRP, ESP,
GRE, IGMP, OSPF, PIM, VRRP, IP-in-IP, PCP, Protocol ID, and None.
After selecting TCP as the Protocol Type, Click the IPv4 Address, Port, IPv4 DSCP and TCP Flag tabs to
display the following page:
Figure 4.141 – ACL > ACL Configuration Wizard – Create IPv4 ACL-TCP
Source: Select the source information. The values are Any, Host and IP.
Destination: Select the destination information. The values are Any, Host and IP.
Source Port: Select the source port value.