D-Link DXS-1210-16TC - Page 6

 Google Chrome
 Firefox
 Safari
 Opera
You will need the following equipment to begin the web configuration of your device:
 A PC with a RJ-45 Ethernet connection
 Standard Ethernet cable
1. Connect the Ethernet cable to any of the ports on the front panel of the switch and to the
Ethernet port on the PC.
2. In order to login and configure the switch via Web-based GUI, the PC must have an IP
address in the same subnet as the switch. For example, if the switch has an IP address of
10.90.90.90 and a subnet mask of 255.0.0.0, the PC should have an IP address of 10.x.y.z
(where x/y is a number between 0 and 255, z is a number between 1 and 254) and a
subnet mask of 255.0.0.0. Enter the IP address 10.90.90.90 in the address box of your
Web browser.
Note: The switch’s factory default IP address is 10.90.90.90 with a subnet mask of
255.0.0.0 and a default gateway of 0.0.0.0.
3. When the following login dialog box appears, enter the username and the password (by
default, the username and the password are empty). Click Login.
