D-Link DXS-1210-16TC - Page 5

installation. Commercially available 6 AWG wire is recommended. The length of the
cable depends on the proximity of the Switch to proper grounding facilities.
 A screwdriver (not included in the accessory kit).
You can connect the switch to a protective ground by following the steps below:
1. Verify if the switch power is off.
2. Attach the terminal lug ring of the grounding cable to the ground screw opening of the
switch with the grounding screw.
3. Attach the terminal lug ring at the other end of the grounding cable to an appropriate
grounding stud or bolt on the rack where the switch is installed.
4. Verify if the connections at the ground connector on the switch and the rack are securely
attached.
Plugging in the AC Power Cord
Plug one end of the AC power cord into the power socket of the switch and the other end
into the electrical outlet (preferably one that is grounded and surge protected).
Power Failure
In the event of a power failure, just as a precaution, unplug the power cord from the switch.
After the power returns, plug the power cord back into the power socket of the switch.
Management Options
The DXS-1210-16TC switch can be managed with the Command Line Interface (CLI),
SNMP and Web GUI.
Command Line Interface (CLI)
The switch can be managed with the CLI by connecting a PC to the console port on the
switch. Alternatively, the switch can be managed, in-band, by using a Telnet connection to
any of the LAN ports on the switch.
SNMP-based Management
The switch can be managed with an SNMP-compatible console program. The switch
supports SNMP v1, SNMPv2c and SNMPv3.
Web GUI
The Web GUI provides an access to multiple configuration and management options of the
switch and allows user to view statistics graphically.
Entering the Web GUI
After a successful physical installation, you can configure the switch, monitor the network
status and display statistics using a web browser.
Supported Web browsers:
 Microsoft Edge
