Figure 3 — Installing the switch in a rack
Installing Transceivers into the Transceiver Ports
The DXS-1210-16TC switch is equipped with the SFP+ ports for connecting the
transceivers.
Figure 4 — Inserting transceivers into the transceiver ports
Grounding the Switch
This section describes how to connect the switch to the ground. You must complete this
procedure before powering on the switch.
Required tools and equipment:
Ground screws (included in the accessory kit): One M4 x 6 mm (metric) pan-head
screw.
Grounding cable (not included in the accessory kit): The grounding cable should be
sized according to local and national installation requirements. Depending on the
power supply and system, a 12 to 6 AWG copper conductor is required for
To Next Page
Loading...
