28D-Link G403 User Manual
Section 2 - Installation
Cellular
Go to Settings > Cellular to congure your cellular connection. You can view data on the LTE modem connected
to the router and enable/disable the function for automatic creation of 3G/LTE WAN connection.
Connection Settings
Service Mode: Select 2G Only, 3G Only, LTE Only, or Auto
to let the system determine.
Connection
Mode:
Select Auto Connect or Manual Conect.
Data Roaming: Enable or disable Data Roaming.
Dial-up Settings
APN Mode: Select Manual or Auto for APN mode.
APN Name: When APN Mode is set to manual, enter the
name of your APN.
PDP Type: Select IPv4, IPv6, or IPv4/IPv6 for PDP type.
Username: Enter your username.
Password: Enter your password
Dial Number: Enter the dial number
Authentication
Type:
Select PAP, CHAP, NONE, or Auto for your
authentication type.
To Next Page
Loading...
