D-Link EXO DIR-3060 User Manual

62D-Link EXO Series Router User Manual
Section 3 - Conguration
IPv6 - Auto Conguration (SLAAC/DHCPv6)
Select Auto Conguration if your ISP assigns your IPv6 address when your
router requests one from the ISP’s server. Some ISPs require you to adjust
settings on your side before your router can connect to the IPv6 Internet.
Click Save at any time to save the changes you have made on this page.
IPv6 DNS Settings
DNS Type Select either Obtain DNS server address automatically or
Use the following DNS address.
Primary DNS Server If you selected Use the following DNS address, enter the
primary DNS server address.
Secondary DNS Server If you selected Use the following DNS address, enter the
secondary DNS server address.
LAN IPv6 Address Settings
Enable DHCP-PD Enable or disable prex delegation services.
LAN IPv6 Link-Local
Address
Displays the router’s LAN link-local address.
If
Enable DHCP-PD is disabled, these additional parameters are available for conguration:
LAN IPv6 Address Enter a valid LAN IPv6 address.
LAN IPv6 Link-Local
Address
Displays the router’s LAN link-local address.

D-Link EXO DIR-3060 Specifications

General

Frequency Bands	2.4 GHz, 5 GHz
Wi-Fi Generation	Wi-Fi 5
Antenna Type	External
Number of Antennas	6
USB Ports	1 x USB 3.0
MU-MIMO	Yes
Processor	Dual-core
Wireless Standard	IEEE 802.11ac
Maximum Wireless Speed	3000 Mbps
Ports	4 x Gigabit Ethernet
Security	WPA3
Memory	128 MB Flash, 256 MB RAM