DIR-X1860 Quick Installation Guide
Conguring Wireless Network
This configuration step is available for the Router, Access point, WISP
Repeater, and Repeater modes.
1. On the Wireless Network 2.4 GHz page, in the Network name field,
specify your own name for the wireless network in the 2.4GHz band or
leave the value suggested by the router.
2. In the Password field, specify your own password for access to the
wireless network or leave the value suggested by the router (WPS PIN of
the device, see the barcode label).
3. If the router is used as a Wi-Fi client, you can specify the same
parameters of the wireless network as specified for the network to which
you are connecting. To do this, click the USE button (available for the
WISP Repeater and Repeater modes only).
4. You can restore the parameters of the wireless network specified before
resetting to factory defaults. To do this, click the RESTORE button.
32
To Next Page
Loading...
Need help?
General
