12
PARTS & FUNCTIONS CONT.
Multiple Dog Model Selection Switch
(RH1202/RH1222V/RH1252B)
Switching between units can be controlled by moving
the toggle selection switch to the desired unit.
Battery Charging Receptacles
The battery charging receptacle is located on the side
of the Transmitter, and on the side of the Collar
Receiver facing the dog’s neck. After charging,
always close the jack with the rubber plug to prevent
foreign particles from getting inside the unit.
Vibration Buttons
(
RH 1220V/1222V)
Pressing the button on the left (#1) of the transmitter
causes the collar to vibrate. Pressing the button to the
right (#2) of the transmitter causes the collar to vibrate
for 1/2 second. After 1/2 second, continuous stimula-
tion will be applied simultaneously with the Positive
Vibration.
Locate and Run/Point Buttons
(RH 1250B/1252B)
Pressing the ‘Locate’ button on the left side (#1) of the
Transmitter will make the Collar Receiver beep.
Pressing the ‘Run/Point’ button on the right side (#2)
of the Transmitter will activate the Run/Point mode on
the Collar Receiver. Press it again and it will go into
the Point only mode. Press the ‘Locate’ button to can-
cel the Run/Point modes. For more information on the
Run/Point mode, see page 17.
To Next Page
Loading...
