17
IMPORTANT:
If a failure code is displayed, the oven will beep continuously until the user presses the CANCEL • SECURE key. The oven will not heat
after a failure code is displayed. Call a qualified appliance technician to repair the oven.
Oven Failure Codes
Clock Display Cause
F0. Touch pad is stuck in depressed position.
F1. Relay circuit failure.
F2. Oven temperature exceeded the clean runaway temperature (self-clean mode only)
or the cooking runaway temperature (cooking modes only).
F3. Short circuit in the oven temperature sensor.
F4. Open circuit in the oven temperature sensor.
F6. Failure in the EEPROM check comparison. (Only time of day and timer will operate.)
F7 Failure of the self-clean automatic door latch circuit.
F8. Failure of the door latch motor. Occurs when the motor runs for two minutes without
the door locking in self-clean mode.
Be f o r e yo u ca l l fo r Se r v I c e
To Next Page
Loading...
Need help?
General
