Dacor DO User Manual

PLANNING
GUIDE
1.7
Specications subject to change without notice. Phone: (800) 793-0093www.dacor.com
DO
Double, Distinctive
™
Wall Oven
(A) Overall
Width
(B) Chassis
Width
(C) Overall
Height
(D)* Chassis
Height
(E) Control
Panel
Overlay
29 3/4”
(75.6 cm)
28 3/8”
(72.1 cm)
49 15/16”
(126.8 cm)
49 1/16”
(124.6 cm)
15/16”
(2.4 cm)
* To top of chassis notch behind control panel
(F) Utility
Cutout Width
(G) Utility
Cutout Height
(H) Utility
Cutout Depth
(J) Control
Panel Depth
(K) Notch
Depth
(L) Chassis
Depth
(M) Notch
Height
5”
(12.7 cm)
5 ¼”
(13.3 cm)
6”
(15.2 cm)
1”
(2.5 cm)
1 5/8”
(4.1 cm)
24”
(61.0 cm)
1”
(2.5 cm)
21 1/8”
(53.7 cm)
ELECTRICAL SPECIFICATIONS
Dedicated Circuit
Requirements
Total Connected Load
240 Vac 60 Hz.,
4-wire,** 40 Amp.
7.8 kW (33 Amp.)
** Two 120 Vac hot (L1 and L2), one neutral, one ground.
The above specifications are for reference only. See the
appliance data plate for exact specifications.
C
J
B
H
G
F
A
K
L
M
E
Chassis Notch
Side View
Control panel
front
Top of
chassis
Top of
chassis
Utility
cutout
Conduit:
60” (152 cm)
Long
D
Product tolerances: ±1/16” (±1.6 mm) unless otherwise stated
MODEL DO230
Document # PG01-008 Revised 10/01/11 Page 1/2
WARNING
• Observe all governing codes and ordinances during planning
and installation. Contact your local building department for
further information.
• This appliance must be installed in accordance with the
accompanying installation instructions.
All manuals and user guides at all-guides.com
all-guides.com

Dacor DO Specifications

General

Fuel Type	Electric
Brand	Dacor
Category	Oven
Installation	Built-In
Color	Stainless Steel
Convection	Yes
Self-Cleaning	Yes
Model	DO
Warranty	2 years

Summary

Installation Dimensions and Tolerances

Product Tolerances

Specifies dimensional tolerances for the appliance installation.

Overall and Chassis Dimensions

Details overall width, height, and depth measurements of the appliance chassis.

Utility and Cutout Dimensions

Provides specific dimensions for utility cutouts and chassis notches.

Cabinet and Countertop Tolerances

Defines acceptable tolerances for cabinet and countertop installations.

Double Wall Oven Cutout Dimensions

Specifies minimum cabinet width, cutout width, and cutout height requirements.

Safety and Electrical Requirements

Installation Warnings

Advises to observe governing codes and contact local building departments for installation.

Electrical Specifications

Outlines required dedicated circuit voltage, frequency, and amperage, and total connected load.