Why won't any of the burners light on my Dacor DOP48M96DL?
S
Sean MoralesAug 3, 2025
If none of the burners are lighting, several factors could be at play. First, ensure the cooktop is properly plugged into a live, grounded outlet. Next, check your fuse box or circuit breaker to see if a fuse has blown or a circuit breaker has tripped; replace the fuse or reset the breaker if necessary. Finally, verify that the gas supply is properly connected and turned on, consulting your cooktop’s Installation Instructions for guidance.
D
Debra Jones DVMAug 10, 2025
Why are the surface burners on my Dacor DOP48M96DL not lighting?
B
Brittany WarnerAug 10, 2025
If the surface burners aren't lighting, make sure the control knob is correctly set by pushing it in and turning it to the Lite position. Also, ensure the burner caps are in place and the burner base is properly aligned. Clean the electrodes, put the burner cap on the burner head, and align the burner base.
E
elizabethriveraAug 18, 2025
Why is my Dacor DOP48M96DL surface burner clicking during operation?
M
Mary WilsonAug 18, 2025
If a surface burner clicks during operation, it might be because the control knob has been left in the Lite position. After the burner ignites, turn the control knob to the desired setting. If the burner continues to click, it is recommended to contact a service technician.
E
Erin RiveraAug 25, 2025
Why are the flames on my Dacor DOP48M96DL Oven surface burner very large or yellow?
T
Tammy HinesAug 26, 2025
Very large or yellow surface burner flames indicates that the wrong burner orifice might be installed. Check the burner orifice size, and contact your installer if you have the wrong orifice (LP gas instead of natural gas or vice versa).
To Next Page
General
