EasyManua.ls Logo

Dacor PGM365 - Gas and Electrical Supply Requirements; Gas and Electrical Installation Warnings; Gas Supply Requirements; Electrical Requirements

Dacor PGM365
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 2
Page 3
NOTES:
1. If cabinet storage space is to be provided directly above the cooktop, the risk of personal injury
may be reduced by installing a ventilating hood that projects horizontally a minimum of 5 inches
beyond the face of the cabinets.
2. Allow a minimum 1/4 inch clearance between the bottom of the any cooktop chassis and all
combustible surfaces, including the upper edge of a drawer installed below the cooktop.
3. Access to the underside of the cooktop and the junction box must be provided for inspection
and service.
4. A fixed shelf should not be installed below the cooktop.
5. Clearance inside the cabinet must allow for proper side mounting bracket installation.
6. All models are designed for 24” (610mm) minimum base cabinet depth.
7. The maximum depth of cabinets installed above cooking tops is 13 inches (330mm)
STEP 1
Verifying the Package Contents
• Use & Care Manual • Hold Down Bracket Kit
• Cleaning Kit • Simmer Plate (SGM Only)
• Grate/Burner Cap Pack • Burner Set
• Gas Pressure Regulator • Grill Drip Pan (SGM464GG Model Only)
• Grill U-burner (SGM464GG Model Only) • Grill Heat Control Channels (SGM464GG Model Only)
• Grill (SGM464GG Model Only) • Grease Control Box (SGM464GG Model Only)
STEP 2
Planning the Installation
Cabinet and Countertop Preparation
The installation of this built-in appliance must be completed by a qualified appliance technician or contractor. Proper installation is the
ownerʼs responsibility.
Carefully check the location where the cooktop is to be installed. The cooktop should be placed for convenient access, but away from drafts
that may be caused by open doors and windows or by HVAC duct outlets. Make certain that gas and electrical power can be provided
in the selected locations. Plan the installation so that all minimum clearances are met or exceeded. Dimensions shown provide minimum
clearances, unless otherwise noted.
WARNINGS:
1. To reduce the risk of personal injury caused by reaching over a hot appliance, cabinet storage
space located directly above the cooktop should be avoided.
2. Keep appliance area clear and free from combustible materials, gasoline and other flammable
vapors and liquids.
3. Failure to provide proper clearances may result in a fire hazard!
4. Do not store combustible materials or items adversely affected by heat immediately below the
cooktop.
5. The back edge of the cooktop must remain a minimum of 2 1/4" (57mm) from any combustible
backsplash material. This will require special cabinet and countertop dimensions.
IMPORTANT:
When installing the cooktop into a laminated (Formica, etc.) or synthetic (Corian, etc.) countertop,
radius the corners of the cutout to prevent cracking of the countertop. Follow the countertop
manufacturerʼs instructions regarding the minimum corner radius, use of heat reflective tape,
reinforcement of corners, etc.

Other manuals for Dacor PGM365

Related product manuals