DAELIM DAYSTAR FI - Engine Oil Level Check; Changing Engine Oil

●Put vehicle in upright position on flat
ground and check engine oil level and
degree of pollution.
●Run engine idle for approximately 2~3
minutes on flat ground and stop engine.
Approximately 2~3 minutes thereafter,
put vehicle in upright position and
check engine oil and verify the oil level
is between the upper and lower level of
oil level gauge.
●Insert oil level gauge, without locking,
and check oil level after removing oil
gauge.
●If the oil level is near lower level,
replenish oil to upper level.
If engine oil is polluted, it seriously affects
the engine life span. Maintain appropriate
level of oil, use correct type of oil and
observe oil exchange period.
●Stand vehicle on the main stand on level
ground and run engine idle (warm up)
for approximately 2-3 minutes.
●Stop engine and place a container under
the engine.
Remove oil level gauge and drain bolt.
●Clean oil filter screen.
●Check the condition of oil filter screen
seal rubber and, O-ring.
●Close oil filter screen, spring, and oil
drain bolt, and replenish oil up to the
upper level of the oil level gauge.
OIL CAPACITY: 1.2
31
ENGINE OIL LEVEL CHECK CHANGING ENGINE OIL
UPPER
LEVEL
LOWER
LEVEL
OIL LEVEL GAUGE
WARNING
●If a torque wrench is not used for this
installation, see your authorized
dealer as soon as possible to verify
proper assembly.
WARNING
●Be sure to keep oil away from
children and pets. Dispose of used oil
properly.
CAUTION
●If a torque wrench is not used for
this installation, see your
authorized dealer as soon as
possible to verify proper assembly.
●Make sure the right and left chain
adjuster graduations are set in the
same position.
●After adjusting chain, check the
rear brake pedal free play.
●New motorcycle adapts endless-
type drive chain. (end-type for
affer-sales service purpose)
After once disassembling chain,
chain clip can be accidentally
removed, so change new one after
disassembling chain even once.