5. Product use procedure
5.1 Before using a device
Use this device only under medical supervision.
5.2 Setup and use
1) Place the device on a hard and flat table, or hang on the bed and connect to a power
outlet.
2) Ensure the cuff is the correct size and securely fitted to the patient.
3) Connect the cuff to the controller with the connectable hose(s).
4) Turn on the power switch at the rear of the controller.
5) Operate the controller by pressing the START/STOP button for the automatic setting
DVT or enter pressure and interval time manually after initial inflation.
6) The controller will operate automatically utilizing the entered settings after the cuff
self-test operation.
7) Press and hold the START/STOP button for 3 sec to stop therapy.
Check therapy parameters are in accordance with medical supervision.
8) Start the operation.
20
DVT-2600
To Next Page
Loading...
