8. MAINTENANCE
General
- Please regularly check the machine and make essential adjustments and repairs.
Maintenance schedule
In the maintenance schedule you can see which parts of your machine that require maintenance,
and with which intervals it should take place. The intervals are calculated based on daily use of the
machine, and may differ depending on the rate of usage.
*See instructions in the section "Machine's safety equipment".
** See instructions in the section "Cutting blades" and "Assembly and settings".
Cleaning
External cleaning
- Clean the machine daily by rinsing it with clean water after the work is nished.
Cooling air intake
- Clean the cooling air intake when needed.
WARNING! The user must only carry out the maintenance and service work des-
cribed in this Operator's Manual. More extensive work must be carried out by an
authorized service workshop.
The engine should be switched off, and the stop switch in STOP position.
Wear personal protective equipment. See under heading "Personal protective
equipment".
The life span of the machine can be reduced and the risk of accidents can increase
if machine maintenance is not carried out correctly and if service and/or repairs
are not carried out professionally. If you need further information please contact
your nearest service workshop.
32
To Next Page