www.daewoopower.bg
7
EN
7. OPERATING INSTRUCTIONS
1. Ensure the backsprayer is empty, adjust the shoulder straps and ensure the backpack sprayer fits
comfortably before filling compartment with water.
2. Whilst removing the filler cap, ensure the filter remains in place. Fill the compartment to the
desired level, DO NOT exceed the maximum fill level.
3. Once the desired level is reached screw the filler cap firmly on to create an airtighr seal. (this
allows for maxium pressure to be achieved)
Securly fit the sprayer onto your back and remove the spray lance from its holder. Hold securly in
your right hand. Then release the pump handle, this achieved by removing the retaining loop.
Pump the handle for up to 6-8 times to produce the pressure required in the compartment. Once the
pressure sprayer is pressurised it is ready for operation.
Depress the trigger on the lance handle to allow spraying to comence. Either use the sprayer in this
method or lock the trigger in the open position by sliding the locking clip into place.
Depending on the type of spray required, you can operate the sprayer with a single jet nozzle, twin
head single jet nozzle or a 4 jet nozzle.
Maintaining pressure whilst spraying can be achieved with 2-3 pumps of the handle during 10-15
seconds of spraying.
To Next Page
Loading...
Need help?
General
