47
Check the function of the brakes at regular, short in-tervals
and, if necessary, have the required adjust-ments or
maintenance operations performed by a technician.
WARNING
Never work on or touch conducting parts on the ignition unit
with the engine running. Always pull the spark plug boot
from the spark plug before starting any work of care or
maintenance. Never perform any work on the machine while it
is running. Any work not described in these Operating
Instructions must be performed by an authorized service
workshop only.
Wheel axles and wheel hubs
These should be lightly greased once a season.
Blade
For safety reasons you should only ever have your blade
sharpened, balanced and mounted by an au-thorized
service workshop. For optimum results it is recommended
that the blade should be inspected once a year.
Change the blade
When changing the cutting tool, only use original replacement
parts.
Wear gloves to avoid cut injuries while changing the blade.
Never install another blade.
• Remove the ignition key.
• Remove the screw to replace the blade.
• Install everything as described in g. Fasten the screw
correctly. The fastening torque in 65 Nm. Replace the screw
and washer, as well, if you replace the knife.
To Next Page
Loading...
