D1146/D1146TI/DE08TIS
MAINTENANCE MANUAL
63
Printed in Jan. 2001 PS-MMA0415-E1A
4) Bearing spread and crush
z Inspection
Check to see that the bearing
requires a considerable amount of
finger pressure at reassembly
operation.
z Crankshaft bearing crush
Install the bearing and cap in the
cylinder block, retighten the bolts to
specified torque, unscrew out one
bolt completely, then measure the
clearance between the bearing cap
and cylinder block using a feeler
gauge.
Standard
0.19 ∼ 0.22 mm
z Connecting rod bearing crush
Install the bearing and cap in the
connecting rod big end, retighten
the bolts to specified torque,
unscrew out one bolt completely,
then measure the clearance
between the bearing cap and
connecting rod big end using a
feeler gauge.
Standard
0.3 ∼ 0.5 mm
M1112
S
read
To Next Page
Loading...
