Daewoo DRP-22 - Setting the Alarm Time; Setting Sleep Timer

ENG
10
SETTING CLOCK (in radio o mode)
1. Press & hold the [ ] button with hours  ashing, then rotate
the [TUNING] knob to adjust the hour.
2. Press the [ ] button with minutes  ashing, and then rotate
the [TUNING] knob to adjust the minute.
3. Press the [ ] button again to con rm the setting.
Notes: You need to reset the time after changing batteries.
SETTING ALARM BY RADIO
You can preset the alarm station following below steps:
1. Turn on the radio, then tune into your favorite station as
radio alarm and adjust your desired alarm volume level.
2. Press & hold the [ ] button immediately and notice “ ”
 ashing on the display to con rm the preset alarm station.
SETTING THE ALARM TIME
1. Press & hold the [ ] button with “ ” and “hour”
 ashing, and then rotate the knob to adjust the hour.
2. Press the [ ] button with “ ” and “minutes”  ashing,
and then rotate the [TUNING] knob to adjust the minute.
3. Press the [ ] button to con rm the setting.
Notes:
1. The unit will turn on automatically and switch to the preset
alarm station on time. It will also be turned o automatically
when it reaches the preset alarm o timer.
2. The unit will move to snooze mode automatically if you
don’t turn o the alarm and it will start alarming again 5
minutes later(3 times at most).
3. Press the [ ] button can activate/deactivate the alarm by
radio. If “ ” shows on the display, it means the alarm by
radio is turned on.
SETTING SLEEP TIMER
To set the Sleep timer function, press and hold the [ ] button
until “ ” symbol  ashing, then rotate the [TUNING] knob to
select your desired auto turn o er time.