ENG
9
LISTENING TO THE RADIO
Install batteries:
Install two R03 (AAA) new batteries observing the battery
polarity diagram on the back of the radio.
Turn on/ o the radio:
• Press the [ ] button.
• Press & hold the [ ] button with “ ” ashing on the display
which indicates setting sleep timer. Rotate the [TUNING] knob
immediately to select sleep timer from 1~120 minutes or select
permanently “ On ”.
Volume adjustment:
Turn on the radio, press the [VOL] button with “
Vol ” ashing,
rotate [TUNING] knob to adjust the volume.
ETM:
Turn on the radio, then fully extend the telescopic antenna,
press & hold the [ETM] button until the frequency start running
to auto scan and store stations into ETM memory. You can
rotate the [TUNING] knob to select those stored station while
the displayed frequency stop advancing.
Notes: You’d better reset the ETM when changing place.
Manual frequency tuning:
Repeat press on the [ETM] button and notices “ETM” disappears
on the display, then rotate the [TUNING] knob for manual
tuning.
Listening to the radio with earphones:
You can listen to FM stereo stations through earphone with
“ ” appears on the display.
Notes:
1. If the volume is below level 8, it will maintain the current
volume when you plug in the earphone; however if the
volume is above level 8, the volume will drop to level
8 automatically. You can adjust the earphone volume
according to your own needs.
2. When the earphone is plugged out, the volume will
automatically set to level 15.
To Next Page
Loading...
