Daewoo DSL15M1TC - Connecting to a PC

- 12 -
System Connections
Connecting to a PC
Follow the steps and the figure below to connect a PC to the unit:
1. Connect one end of the VGA cable to the VGA input jack on the right side of the unit’s rear
panel and the other to the PC.
2. Connect one end of the audio cables to the PC audio input jack on the right side of the unit’s
rear panel and the other to the PC audio output jack.
3. Set the PC’s resolution to 1024×768@60Hz.
After connection, turn on the unit and the PC and then press the SOURCE button to select VGA
mode.