Daewoo DTD 7200 - Handset Settings - Alarm and Ringing

24
 FLASH TIME
The user can select to change the flash time (100ms, 300ms, 600ms and 1000ms).
1) Press
key, then press △ or ▽ key to select FLASH TIME item.
2) Press
key to enter.
3) Press △ or ▽ key to select the desired flash time among 100ms, 300ms, 600ms and 1000 ms.
4) Press
key to confirm your selection.
 MODIFY PIN
This function allows the user to change the pin number of the currently active base.
1) Press
key to confirm.
2) Then press △ or ▽ key to select MODIFY PIN item.
3) Press
key to confirm, and the display shows PIN?.
4) The user will first be requested to entry the existing PIN code for the base by using numerical keys,
then press
to confirm.
5) If the old code is validated, the user will be prompted to enter a new PIN code (4 digits), press
to confirm.
6) Once a new PIN code has been entered, the user will be requested to repeat to input the new PIN
code.
7) Press
to confirm, the code will be stored to the base and a tone sounded.
 BASE DEFAULT
This function allows the user to restore the base setting to the factory default.
1) Press
key, then press △ or ▽ key to select BS DEFAULT item.
2) Press
key to confirm.
3) The user will be prompted to enter the PIN CODE, the display shows PIN?, then press numerical keys
to input code.
4) If the PIN code is validated all base settings will be returned to the factory default.
Handset Menu function 4: HS SETTINGS
The user is able to change a number of the settings for the handset to their own individual preferences. Press
△ or ▽ key to select HS SETTINGS. Then you can do below:
 ALARM
The user is able to set the alarm on the handset and adjust the alarm settings.
1) Press
key, the first sub-menu is ALARM item.
2) Press
key to confirm.
3) Press △ or ▽ key to select ON or OFF, and press
to confirm .Selection of ALARM OFF will
turn the alarm off, and the user is dropped back to the “ALARM” menu. Selection of ALARM ON
option will turn the alarm on, then the user will be requested to set the alarm time.
4) After select ON, press
key to start the time settings of alarm, 12-00 displayed with “12” flashing,
5) Press △ or ▽ key to edit the alarm time (including AM/PM)
6) Press
key, the user will be presented with a further option to select to SNOOZE ON or
SNOOZE OFF to enable or disable the snooze function on the alarm.
7) Press
key to confirm your selection. And the alarm icon will show on LCD.
 Startup alarm:
In idle state, the alarm will ring at very sharp hour you have set.