Daewoo DTD 7200 - Ring Setup; Tone Setup

25
 Intermit alarm:
During the alarming, press any key except
, and will begin to ring after 5 minutes. When a call comes,
the alarm will be intermitted too.
 Close alarm:
Press
to close alarm or enter alarm setting state, select OFF.
 RING SETUP
The user is able to change the handset ringing on internal calls and External calls. There are 10 ringer
melodies and 5 different volume levels can be set.
1) Press
key, then press △ or ▽ key to select “RING SETUP” item.
2) Press
key to enter.
3) Press △ or ▽ key to select the INT RING and EXT RING setup.
4) Press
key to confirm.
5) Press △ or ▽ key to select the MELODY and VOLUME setup.
 If select MELODY,
1) Press
key to confirm.
2) Press △ or ▽ key to select desired melody, the corresponding melody sound can be
heard with the selection.
3) Press
key to confirm your selection.
 If select VOLUME,
1) Press
key to confirm.
2) Press △ or ▽ key to select desired ringer volume 1- 5, the corresponding volume sound
can be heard. If you want to switch off select OFF.
3) Press
key to confirm your selection.
NOTE：1) If you select ring OFF for INT RING, when transfer call to this unit, it will not ring;
2) If you select ring OFF for EXT RING, there will be a ringing off icon
display on LCD and when
there is an incoming call, the handset will not ring. (Shortcut key: press and hold
key to
switch the handset external call ring on/off).
 TONE SETUP
The user is able to change the handset tone settings.
1) Press
key, then press △ or ▽ key to select TONE SETUP item.
2) Press
key to enter.
3) Press △ or ▽ key to select the KEY TONE and BATTERY LOW, RANGE ALARM setup.
4) Press
key to confirm.
5) Press △ or ▽ key to select the ON or OFF to enable/disable the sounding of a beep
respectively.
6) Press
key to confirm your selection.
NOTE: after this setting,
 a beep for key tone will sound when a key is pressed on the handset.
 a beep for battery low then the battery is low.
 a beep for range alarm will sound when the handset is out of ringed of the base
 LANGUAGE
1) Press
key, then press △ or ▽ key to select LANGUAGE item.