lubricating
The pulsator can’t rotated in
negative or positive
1.Wash timer damaged
2.Selector damaged
1.Replace the wash timer
2.Replace the selector
Not well drain or no drain 1.Some foreign matters clog the drain valve
2.The drain valve open height not reach the
right position
3.Keep the drain pipe too high
1.Clean the foreign matters
2.Adjust the drain valve right height
3.Lower down the drain pipe
Water leakage 1.The reducer screws loosen
2.The reducer seal circle damaged
3.The joint place of pipe is not sealed well
or the pipe surface damaged
4.Rubber cap damaged
5.The drain valve is not sealed well
1.Tighten the reducer
2.Replace the reducer seal circle
3.Glue the pipe joint place again or
replace the pipe
4.Replace rubber cap
5.Adjust the drain valve pole’s right
height or clean the foreign matter or
replace the drain valve
The drain pump failure to
drain when washing
1.Drain valve not opend
2.Some foreign matters in the pump
3.The drain pump switch damaged
4.The drain pump damaged
1.Open the drain valve
2.Clean the foreign matters
3.Replace the pump switch
4.Repalce the drain pump
The drain pump failure to
drain the water when spin
1.The spin timer damaged
2.Some foreign matters in the pump
3.The drain pump damaged
1.Replace the spin timer
2.Clean the foreign matters
3.Replace the drain pump
To Next Page
Loading...
