17
• ELECTRICAL GROUNDING INSTRUCTIONS
This appliance is equipped with a three-prong(grounding) plug for protection against possible shock hazards. If
a two-prong wall receptacle is encountered, the customer is required to contact a qualified electrician and have
the two-prong wall receptacle replaced with a properly grounded three-prong wall receptacle in accordance
with the National Electrical Code.
ELECTRICAL REQUIREMENTS
WARNING :
To avoid death, personal injury or properly damage due to electrical shock, this unit must be
grounded.
Do not under any circumstances cut or remove the round grounding prong from the plug.
Do not use a two prong adapter.
WARNING :
Do not remove, modify or immerse this plug. If this device trips, the cause is to be corrected before
further use, see owners manual.
This device must only be plugged on appropriate wall outlet.
Do not use on extension cords.
• USAGE OF POWER CORD(AFCI OR LCDI)
Testing:
CASE 1 : Lamp exists
1. Plug into power receptacle.
2. If light is not on, press “RESET” button, light should turn on.
3. Press “TEST” button, light must turn off.
4. Press “RESET” button again for use. Light should turn on.
Do not use of above test fails.
CASE 2 : Lamp not exist
1. Plug into power receptacle. Turn on Unit.
2a. If unit operates normally, press “TEST” button. Unit should trip.
Press “RESET” button again for use.
2b. If unit not operate, press “RESET” button for use. Unit should operate.
Do not use if above test fails.
To Next Page
Loading...
