6
5. GENERAL INFORMATIONS
1. CHANGING AIR FLOW DIRECTION
Air flow deflectors divert air from center flow to left or right.
Adjust deflectors for desired air flow pattern.
2. AIR FLOW AROUND UNIT
Check in door grill and outdoor louvers for air flow obstructions. Do not block air flow to and from unit. The
outdoor coil should be checked and periodically cleaned for debris that may collect and block unit air flow. If air
flow is obstructed or deflected back into unit, the compressor may cycle on and off rapidly, causing early
compressor failure.
3. Electrical Grounding Instructions.
This appliance is equipped with a three-prong(grounding) plug for protection against possible shock hazards. If
a two-prong wall receptacle is encountered, the customer is required to contact a qualified electrician and have
the two-prong wall receptacle replaced with a properly grounded three-prong wall receptacle in accordance with
the National Electrical Code.
4. USE OF EXTENSION CORDS (ONLY DWB-056C)
Because of potential safety hazards under certain conditions we strongly recommend against the use of an
extension cord. However, if you still elect to use an extension cord, it is absolutely necessary that it is earthed
and the marked rating of the extension cord should be 250V 10A or more for Model DWB-056C.
5. USE OF LCDI OR AFCI POWER CORDS(ONLY DWC-056CL)
Testing:
CASE 1 : Lamp exists
1. Plug into power receptacle.
2. If light is not on, press “RESET” button, light should turn on.
3. Press “TEST” button, light must turn off.
4. Press “RESET” button again for use. Light should turn on.
Do not use of above test fails.
CASE 2 : Lamp not exist
1. Plug into power receptacle. Turn on Unit.
2a. If unit operates normally, press “TEST” button. Unit should trip.
Press “RESET” button again for use.
2b. If unit not operate, press “RESET” button for use. Unit should operate.
Do not use if above test fails.
To Next Page
Loading...
Need help?
General
