Daewoo DWF-1095 E Series - Concerning Operation

29 30
CONCERNING DRY
PROBLEM
THE
WASHING
MACHINE
DOES NOT
SPIN.
CHECK POINT
Is the door open?
Is the display error
‘EE’?
Is the display error
‘LE’?
Does the fan motor
rotate?
Does the safety s/w
operate normally?
Is the connection condition
of terminal good?
Is the fuse defective
(AC220~240:1.25A)
(AC110~127:2.5A)
Is the connection
condition of connector
and terminal good?
Is the thermal fuse
defective?
Is the resistance of
heater 150~450Ω?
Is the connection
condition of termianl
good?
CAUSE SOLUTION
Close the door
Does the water
supply continue?
Pressure switch is
defective.
Change the pressure s/w
Check the ‘WATER IS
NOT SUPPLIED’.
Door s/w is defective.
Does the door s/w
operate normally?
Change the door s/w
Door Ass’y is
defective
Fuse is defective
Fan motor is
defective
Safety s/w is
defective
PCB ASSY is
defective.
Thermal fuse is
defective
PCB ASSY is defective
Heater is defective
Change the PCB ASSY
Change the heater
Does the warm air
supply?
Is the fuse
defective again
Change the fuse
Change the fan motor
Change the safety s/w
Change the PCB ASS’y
Change the Thermal fuse
Is the projection of
door good?
Change the door
Ass’y
YES
YESNO
NO
YES NO
NO
YES
YES
NO
YES
YES
NO
NO
YES
YES
YES
YES
NO
NO
YES
NO
CONCERNING OPERATION
PROBLEM
THE
INDICATOR
LAMP(L.E.D)
DOES NOT
LIGHT UP
WHEN THE
POWER
BUTTON IS
PRESSED.
PROGRESS
LAMPS(LED)
DO NOT
LIGHT UP.
MOTOR
ROTATES
WHEN
START/HOLD
BUTTON IS
NOT
PRESSED.
ABNORMAL
NOISE
DURING
WASH
PROCESS.
CHECK POINT
Is the plug connect-
ed to electric outlet?
Is the condition of
power button good?
Is the conncetor of
the P.C.B. ASS’Y
connected properly?
Is output voltage of
the transformer
normal?
Do you press
START/HOLD button?
Does the pressure switch
operate normally?
Check the output
voltage of P.C.B ASS’Y
Is the strange noise
generated when the
pulsator rotates in
TEST MODE of P.C.B
ASS’Y?
Is the V-belt worn
out?
CAUSE SOLUTION
Connect the plug.
Change P.C.B ASS’Y.
Connect the connector
properly.
Change the
transformer.
Change P.C.B ASS’Y.
Press START/HOLD
button.
Replace P.C.B ASS’Y.
Change the pressure
switch.
Change P.C.B ASS’Y.
Remove the foreign
matter.
Change the V-belt.
Power button is
defective
Improper connection
of the connector.
Transformer is
defective
P.C.B. ASS’Y is
defective.
P.C.B ASS’Y is
defective.
Pressure switch is
defective.
P.C.B ASS’Y is
defective
There is foreign matter
between pulsator and
tub.
V-belt is defective.
YES
YES
YES
YES
NO
NO
NO
NO
NO
YES
YES
Abnormal
YES
YES
NO
NO