16
If the measured water supply is less or more than 7.
the proper water supply, take action as below.
7-1) If less than the minimum of proper water
supply
Change the water supply set value to greater than '5'
by pressing the dispenser button.
7-2) If less than the maximum of proper water
supply
Change the water supply set value to lesser than '5'
by pressing the dispenser button.
7-3) After change the water supply set value,
determine the water supply over repeating items
5-6 above.
The water supply set value is changed as follows
depending on pressing 'dispenser' button once.
5 → 6 → 7 → 8→ 9 → 10 → 12 → 14 → 16 → 18 →
20 → 22 → 3 → 4
The initial predetermined value of water supply is •
'5'
If the measured water supply is proper, hold the 8.
water supply adjustment mode by pressing 'Lock'
button once.
To Next Page
Loading...
