EasyManua.ls Logo

Daewoo KBE-6R2SSS - Installation

Daewoo KBE-6R2SSS
26 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
1. Steady, flat location
This oven should be set on a steady, flat surface.
This oven is designed for Built-in use only.
2. Leave space behind and side
All air vents should be kept a clearance. If all vents are covered during operation, the oven may overheat and, eventually,
cause failure.
3. Away from radio, and TV sets
Poor television reception and radio interference may result if the oven is located close to a TV, Radio, antenna or feeder
and so on.
Position the oven as far from them as possible.
4. Away from heating appliances and water taps
Keep the oven away from hot air, steam and splash when choosing a place to position it, or the insulation might be
adversely affected and breakdowns occur.
5. Power supply
•Checkyourlocalpowersource.
This oven requires 230V, 50Hz.
•Thevoltageusedmustbethesameasspecifiedonthisoven.Usingahighervoltagemayresultinafireorother
accident causing oven damage. Using low voltage will cause slow cooking. We are not responsible for damage
resulting from use of this oven with a voltage of ampere fuse other than those specified.
•Thisapplianceissuppliedwithcableofspecialtype,which,ifdamaged,mustberepairedwithcableofsametype.
Such a cable can be purchased from DAEWOO and must be installed by a Qualified Person.
6. Examine the oven after unpacking for any damage such as:
A misaligned door, broken door or a dent in cavity.
If any of the above are visible, DO NOT INSTALL, and notify dealer immediately.
7. Do not operate the oven if it is colder than room temperature
(This may occur during delivery in cold weather.) Allow the oven to become room temperature before operating.
4. INSTALLATION
CONNECTION OF ThE OvEN
L
N
The Power cable specification is H05RR-F or H05VV-F, 1.5~2.5mm²,
min length.1.5m Supply cord must be of sufficient length to be
connected to the oven.
Open the rear connection cover of the oven with a screwdriver and
loosen the screws of the cable clamp before you connect the power
lines to the relevant connection terminals. The oven is earthed via the
( )-terminal.
If the oven is connected to the mains with a plug, this plug must remain
accessible after the oven is installed. DAEWOO will take no
responsibility for accidents that originate from a missing or faulty earth
connection.
KBE-6R2SSS_6R2SMO(SM)_프랑스향.indd 5 2014-07-18 오후 4:34:21

Related product manuals