Care and Use of your Jug Blender
• Always disconnect the Jug Blender from the mains power supply
before cleaning.
• Wash the jug only in warm soapy water – CAUTION: the
blades inside the jug are not removable and are very sharp;
extreme caution should be taken whilst cleaning the inside of the
jug.
• Clean the outside of the Base Unit with a clean damp cloth. Never
clean with harsh or abrasive cleaners.
• Do not submerge the base unit in water or any other liquids.
Technical Data
Voltage : 220-240V ~ 50/60Hz
Rated power : 500 W
Capacity : 1.5L
Model : SDA1088
Fitting a new plug
If for any reason you need to fit a new plug, the flexible mains lead
must be connected as shown below. The wires in the mains lead fitted
to this appliance are coloured in accordance with the following code:
Brown wire = Live (L)
Blue wire = Neutral (N)
Green and Yellow = Earth (E)
If colours of the wires in the mains lead of this appliance do not
correspond with the coloured marking identifying the terminals in
your plug, proceed as follows:
To Next Page
Loading...